The dimensions you provide the software should be from center of wall to center of wall. Typical framing material = nominal 2x4 studs (actually 1 3/4"x3 1/2" finished) ![]() ![]() It is most likely that the software is using that figure for nominal wall thickness. But, if you want to compensate, add 4.5" to each measurement you make that is from wall to wall. If you've done any architectural drafting, this should make total sense. In other words, the software was taking your dimensions and assuming that they were from center of wall to center of wall. Sounds like you were getting centerline dimensions for the walls. ![]() But when I did that, I found I was coming up a few inches short, even though I knew certain things would fit.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |